K Series Special Function Setting
SAGA1 PLL series:
Function setting (for SAGK1-K1, K2, K3, K4):
Function setting (for SAGK1-K1, K2, K3, K4):
The information below is taken from the “K Series Advanced User Manual”. It is presented here to provide some useful term definitions and is presented here for “information only”. This material is not designed to replace or supercede the information in the manual itself.
Manual Channel Scan (if enabled) Precaution: In order to maximize signal strength without having any disturbance pleases make sure transmitter and receiver close to each other as possible when operating this function. Working principles of Manual CH Scan: First, the transmitter sends a command signal, requesting the receiver to automatically search for the best operating frequency at the moment. When this command has been received and confirmed, receiver will start searching for a new suitable frequency and it will be updated and restored as the new operating frequency into both the Transmitter and Receiver. Standard procedure of operating Manual CH Scan 1. Press “EMS” mushroom, then turn rotary key to “OFF” position. 2. Press and hold the “START” push button. 3. While still pressing the “START” button, turn the rotary key from the “OFF” to “ON” position. 4. Release “START” push button and LED indicator flashes Green, Yellow, and Red sequentially. 5. Press “ UP “ Push button. LED indicator will flash Yellow. 6. When the LED indicator turns from Yellow to Green and vanishes, the new frequency has been updated successfully. 7. When the new frequency has been updated, turn the rotary key from “ON” to “OFF” position. “Manual CH Scan” is completed. Note: If LED indicator turns from Yellow to Red and vanishes, the process failed. If this happens, repeat the processes starting with Step 1. Remote Pairing (if enabled) Remote Pairing works as follows: Initially, the transmitter will search the receiver or receivers that are requesting to be matched. Next, as the receiver has been found and confirmed by operator, the receiver will upload its function settings: e.g. ID-code and frequency into transmitter in order to pair a matched transmitter and receiver. This performance eliminates the trouble of having to physically access the receiver. Standard Procedure for Operating Remote Pairing 1. Press EMS” mushroom and turn rotary key to “OFF” position. 2. Press and hold “START” push button, 3. While still pressing the “START” button, turn the rotary key from “OFF” to “ON” position. 4. Release “START” push button and LED indicator flashes Green, Yellow, and Red sequentially. 5. Press “DOWN” push button and the LED indicator will flash Green and Red, which indicates that the Transmitter is doing the task of searching for the matched Receiver. 6. When matched receiver is found, the LED indicator will turn to Green. 7. To double-check that the receiver which has been found is right one or not, the operator can press the “START” push button to verify it by the receiver power indicator and the beeping from the receiver. 8. If the transmitter finds a receiver which is not correct one, press the “ DOWN” push button, repeat the procedure until correct matched receiver is found. 9. When the transmitter finds a confirmed and matched receiver, press the “UP” push button and the LED indicator of the ransmitter will flash yellow which means data is going to be downloaded into the transmitter. 10. When the LED indicator of the transmitter turns from yellow to green, press the “ UP “ push button to confirm it. Then the LED indicator of transmitter will flash green four times showing that all data has been transferred completely. 11. Turn rotary key from “ON” to “OFF” position. 12. “Remote Pairing” is completed. Note: If there is no receiver found, the LED indicator of the transmitter will flash red four times, which means the “Remote Pairing” processes have been aborted. |